Are you at the right place ?

Are you at the right place ?

Left Continue shopping
Your Order

You have no items in your cart

Free Shipping USA on orders $100 and over


Don’t panic! It’s really simple and much easier than doing muscle-ups.

First, keep in mind that the vinyl you have bought is no typical sticker, it is much more! So you need to make sure all parts of your sticker design are transferred.

Follow these steps that we have taken in the car of one of our Cocowod crossfitters....

STEP 01. Clean the surface where you want to place your sticker and ensure the surface is dry.

STEP 02. Press firmly over the carrier sheet using the scraper provided with your sticker.

STEP 03  Take special care not to miss the small details - usually the letters or small details of the design – by firmly running the scraper over them to the edges.

STEP 03. Carefully remove the back carrier sheet, making sure that all elements of the design have transferred to it. If not, go back to the previous step and try again.

STEP 04. Confirm exactly where you want to put your sticker and start to place it on your surface. Be careful, the carrier sheet is very sticky! Don't bring it too close to the surface before you are ready to stick it because you might not be able to unstick and reposition it.

Step 06. Now run the scraper firmly over the carrier sheet again. Be patient and run the scraper over the design for about two minutes to make sure it sticks smoothly to your surface and you remove any air bubbles.

STEP 07. We are almost there. This step is the most complicated. Remove the top carrier sheet slowly and vertically, checking that all parts of the design remain stuck to your surface... If not, go back to the previous step and try again.

Et voila! Congrats, you've done it!

And now drive your crossfitter car around the world...

Thank you for shopping at Cocowod!

Free Return Easy. No questions
Handmade We pay attention to every detail
Trust Us +700 athletes have rated us 5 stars